|
Models
The incline styles available consist of four specific models to suit your particular requirements.
Model I
Model I conveyors are used when you can use a straight conveyor and your angle of incline is between 10 to 50 degrees. They are commonly used on the sloped pitch of a bin top or anywhere the angle is too great for a standard type of drag conveyor.
Model IC
Model IC conveyors are used when you want to convey material horizontally for a certain distance and then curve the conveyor up at angles of 50 degrees or less. These are commonly used for truck or rail receiving where you want to eliminate having the boot of a bucket elevator in a pit. They are also used to gain extra hopper capacity by having a deeper hopper without having to also lower the inlet point of the equipment you are feeding into.
Model DC
Model DC conveyors are used when you want to convey material horizontally for a certain distance, then curve the conveyor up at inclines up to 90 degrees and the reverse curve back to an incline of 50 degrees or less. These would also be used in places that you would select the above ‘IC’ conveyor but have to clear an overhead or ground obstacle that you cannot clear with just one curved section.
Model ICV
Model ICV conveyors are used when you want to convey material horizontally for certain distance and then curve the conveyor up at inclines from 51 to 90 degrees. These would be used in places that you would select the above ‘IC’ conveyor but need the steeper incline ability.
NOTE: All prices and dimensions are subject to change without notice.
|
